Board logo

Powercommander 3 USB Yamaha R1 Wiring Loom Help - need pinout
hobbsy - 13/11/12 at 06:22 PM

Hi all,

I have a PC3 USB which I'd like to fit to my R1 Fury (I currently have a PC3R fitted).

The wiring loom is toast (it was removed from a R1 that went up in a fireball at Mallory).

However if I apply 12V it appears to light up ok.

On the PC3 USB I have about a foot of cable that is good - the original 4 and 6 way connectors were cut off.

I have removed the 4 way and 6 way plug and sockets from a spare loom - so if I can solder these on to the chopped off loom it should be back in business.

UPDATE Now got the info I need from Dynojet! So I don't need anything else (other than what I can look up in the Yamaha wiring diagrams). I will leave it up here for anyone else who needs this info.

PC3 USB wires:

Red - +12V
Black - GND

White w/ yellow tracer – Injector #2 signal output
White w/ blue tracer - Injector #4 signal output
White w/ orange tracer - Injector #1 signal output
White w/ green tracer - Injector #3 signal output

Black w/ white tracer – digital ground (TPS ground reference)

Grey – TPS analog signal input (0-5 v input)
Green - Injector #3 signal input
Yellow - Injector #2 signal input
Orange - Injector #1 signal input
Blue - Injector #4 signal input

[Edited on 13/11/12 by hobbsy]

[Edited on 13/11/12 by hobbsy]