Board logo

ITG Backplate templates.
r1_pete - 13/2/14 at 09:45 AM

I'm at the stage building the throttle body set, where I need to start thinking about air filters, I don't have room to ducs an airbox, so will be going with an ITG JC100 size filter to fit the 6 bodies and trumpets.

For a bit of cut aluminium sheets, the backplates are silly money, does anyone have, or know a source of templates for these, I know I could work it out when I get the filter, but I'm trying to delay the spend.

Cheers.

Pete.


Jenko - 13/2/14 at 01:52 PM

I purchased mine from DanST Engineering......much cheaper, and probably better quality. Maybe worth giving him a shout to see if ITG can be done.

http://stores.ebay.co.uk/DANST-Engineering


r1_pete - 13/2/14 at 03:54 PM

Good shout, I'll give Dan a try