Board logo

Rover V8 Inlet trumpet ID
r1_pete - 23/6/14 at 01:55 PM

Can anyone tell me the inside diameter of the Rover V8 injection trumpets? Just wondering if I can make a set fit my Triumph throttle bodies
Cheers.
Pete.

Manifold2
Manifold2

40inches - 23/6/14 at 02:44 PM

I have a RV8 injection plenum in the garage Pete, you can have it if it is any good to you.

r1_pete - 23/6/14 at 03:00 PM

Cheers Dave.

I'll arrange to call in one evening next week, just enjoying an ice cold Mythos and a catch up, after a hard day by the pool here in Crete...

Have you got the replacement engine in yet??

40inches - 24/6/14 at 07:29 AM

quote:
Originally posted by r1_pete
Cheers Dave.

I'll arrange to call in one evening next week, just enjoying an ice cold Mythos and a catch up, after a hard day by the pool here in Crete...

Have you got the replacement engine in yet??


Holidays can be so tiring,can't they?
Engine hung on hoist ready to go in. Trying to sort out a small ECU problem, the C to E/F engine isn't a straight swop after all

shaunod - 1/7/14 at 07:50 PM

If memory serves they are about 38mm ... we used to fit 45mm radiused ally versions and had to port out to fit them in.

Ugg10 - 1/7/14 at 08:15 PM

I am looking at adding these to my triumph rs sprint tbs, not the same as yours but may be a similar diametre, price look reasonable as well. Id will be something like 42mm i recon.

Car Alloy Cold Air Funnel Duct End Ram Pipe BLUE 70mm front / 46mm rear