Hi All, another Sunday night silly question from me i'm afraid.


As per my other thread I am planning on running a swirl pot setup on my R1 powered MNR. All of the connections in my fuel system apart from the engine and standard bosch pump are -6 fittings. I've just ordered a load of -6 Teflon stainless steel fuel hose for the fuel system.

For the parts of the system with the -6 fittings, this will be straight forward, but how do I secure the fuel hose over the barbed fittings on the standard bosch fuel pump (8mm & 12mm) - will normal hose clamps work, or are there different hose clamps that should be used with this type of fuel hose?

Thanks

G

You can get a finisher which is basically a jubilee clip with an anodized cover to match the JIC fittings.

I think these are the buggers you need:

�� MIKALOR DOUBLE EAR HOSE CLIP O CLAMP - MULTIPLE PACK SIZES - CHEAPEST ��

These?
4pcs -8 AN 8 AN8 STAINLESS STEEL / NYLON BRAIDED HOSE CLAMP COVER FINISHER BLUE

These?
4pcs -8 AN 8 AN8 STAINLESS STEEL / NYLON BRAIDED HOSE CLAMP COVER FINISHER BLUE