Hi Guys,

Trying to configure sequential injection on an 1800 Ford Zetec blacktop 4 cylinder engine.

I have an additional MS2X expansion card fitted which has a VR conditioner circuit for cam input and additional injector drivers to facilitate sequential injection

Got it all wired up and running pretty good. Problem is that I'm not seeing any cam signal on the composite logger. On further investigation I can see that Cam Input is greyed-out on the ignition options page when using the toothed wheel option that I have selected.

I am using all the OEM sensors and obviously need to trigger off the camshaft (I think) to enable fully sequential injection.

Cheers,

Paul.