Hi guys,

I have recently acquired an omex 500 ecu to run my 2.0 zetec in a budget race that Im building, to race in the mag sevens series limited to 152bhp

I am planning on using Ford throttle body with an inlet plenum built by me......GBS, stainless exhaust with no CAT,

I am after an installation guide or user manual and also a Map to run the zetec, base or one that someone played, does anyone have these to hand or will I have to contact OMEX?

regards Jon

I've just installed an Omex 600 on the rally car and the guys at Omex couldn't have been more helpful, just drop them an email and you get a response within 2-3 days, after Id confirmed the engine spec I had a base map which the car started up on straight away. Car just needs mapping properly now

Manuals and things are here
http://omextechnology.co.uk/page11.html#EngineManagement


Good luck

I got a response back from Omex, link to the manual and a map to run my zetec

I Have a bought an RS232 to USB lead to plug into my laptop to connect to my Omex 500, could someone point me in the right direction to installing the correct driver as at the minute the computer doesnt pick up the ecu

regards jon