Hi,

I am starting the build of my MSnSE set-up and will probably be seeking lots of confirmation of the steps I am taking on this forum, sorry in advance. I have looked at the web site a lot but still get questions that I can't find the answer for.

First one: When building the relay board I am not planning to use a fast idle facility on my engine so do I just ignore the fast idle relay jumper?

depends on which board mod your using to convert to spark output.

one of the mods uses the Fidle output to fire the coils(through the EDIS).

the relay link is to allow the signal through the relay board, and into the EDIS.

hth

Ray

I am going for wasted spark with two VB921 so not using EDIS