hi there guys,

after reading scutters post today about his duff edis module i came across a problem in the diagrams that i had and what he was using, can someone please advise which of the following is correct?



as you can see the wiring the the coil pack is different. mine is wired up like the one on the left

cheers

Wont make any difference as far as I can see - it's just 1/4 and 2/3 plugs will be swapped around .

I used the picture on bottom when doing my megajolt and seems ok.

Rich

i used the bottom one

Bottom one looks correct

Just to confuse the issue, been out and checked, mines running the top picture.

ATB Dan.

I used the bottom one with my Megajolt. As said above - it just means that you have to swap the plug lead pairs (mine match the legend on the coil after using the lower drawing).

It won't be a problem, as has already been said.

If it's round the wrong way, just swap the plug leads over.

Chris

Interesting - the Autosport Labs (Megajolt) website now has the following diagram:



You can see in the top one that it agrees with the top diagram in the original post!

I'm confused...

you see this is where im now confused, does it or doesn't it matter. im going to change mine to the second (the one on the right hand side) as that seems to be the majority rule.

It really dose'nt matter - at the end of the day all your doing is fireing two coils connected to four plugs................which way round they are connected makes no difference at all (hence the different diagrams....)

yea i wired up using the top digram and my engine ran but lumpy as hell, then stopped.

it took me ages to work out the diagram was wrong.

used bottom and it worked fine