delboy
|
| posted on 1/2/09 at 08:55 PM |
|
|
Pinto Inlet Manifold Plate
I'm intending to fabricate an inlet manifold for my pinto to take R1 carbs. I need to provide a CAD drawing of this so that it can be cut on a
flow jet. I had intended to do this at the Christmas break, but as always other things seem to get in the way of making progress other than a a
snails pace. Before I set about trying to measure and draw one, does anyone have one already which they would be prepared to share? Any help much
appreciated.
|
|
|
|
|
blakep82
|
| posted on 1/2/09 at 09:09 PM |
|
|
is a CVH a pinto? i forget...
if it is,
here you go!
jason at short track is on here too 
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
jacko
|
| posted on 1/2/09 at 09:26 PM |
|
|
Inlet manifold gasket  then make one with a drill and file it will keep you fit and warm
|
|
|
delboy
|
| posted on 1/2/09 at 09:28 PM |
|
|
No, a pinto is a single overhead cam engine, unfortunely different from a CVH. I did look on the bay, as I knew Jason sold plates there, but he
doesn't advertise one for a pinto, and when I sent him a sellers question before asking about one, I didn't get a reply. So I assume he
doesn't do them.
|
|
|
RichardK
|
| posted on 1/2/09 at 09:33 PM |
|
|
I think Flak Monkey has one, maybe worth an ask.
Cheers
Rich
[Edited on 1/2/09 by RichardK]
Gallery updated 11/01/2011
|
|
|
short track 123
|
| posted on 1/2/09 at 10:20 PM |
|
|
Hello All
Best way to contact us is by Email EBay are getting hot on sales out side of listings.
Have sent u2u about pinto inlet flange.
Shorttrack Motor Sport Email
Jason
Shorttrack MotorSport Ltd
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
flak monkey
|
| posted on 2/2/09 at 06:09 PM |
|
|
Dxf attached, but please check it against a gasket as it might need tweaking a bit. I cant remember if I finished it off or not...
Cheers,
David
Sera
http://www.motosera.com
|
|
|
.jpg)
