lotusmadandy
|
| posted on 28/1/10 at 07:43 PM |
|
|
GSXR injectors
Hi all,
I am planing to fit a set of k4 GSXR 1000 throttle bodies to my 2 litre zetec.Does anyone know if the injectors will flow enough fuel for the
zetec?
Cheers
Andy
|
|
|
|
|
scootz
|
| posted on 28/1/10 at 07:45 PM |
|
|
I would say they will be more than adequate!
It's Evolution Baby!
|
|
|
Miks15
|
| posted on 28/1/10 at 07:48 PM |
|
|
I would imagine so, the GSXR runs 180 odd HP?
Should be more than enough for a zetec
|
|
|
lotusmadandy
|
| posted on 28/1/10 at 07:49 PM |
|
|
Cheers Scootz,Miks15.that was quick!!
Andy
[Edited on 28/1/10 by lotusmadandy]
|
|
|
will121
|
| posted on 28/1/10 at 08:25 PM |
|
|
think they are flow rate of 270 equates to be good for about 200bhp good previous thread
link
|
|
|
matt_gsxr
|
| posted on 29/1/10 at 06:46 PM |
|
|
These can yield higher car BHP than bike BHP as 0.9ms is needed for the (opening+closing). Lower peak RPM means less "wasted" opening and
closing time. So, whatever BHP you can get in the bike you can get more in the car.
On this same point, if you go for more than 1 squirt per cycle you get to the maximum flow rate earlier (as you are opening and closing more often).
Just something to think about if you are planning on a clever injection approach (i.e. sequential). Mine ran better at low RPM on 2 squirts per
cycle.
Matt
|
|
|
lotusmadandy
|
| posted on 29/1/10 at 08:03 PM |
|
|
Thanks for the advice guys,my mind is made up now to use the bike injectors.
Andy
|
|
|
Jenko
|
| posted on 3/2/10 at 10:00 AM |
|
|
And just to 100% confirm this, I'm running 200bhp on the GSXR600 injectors!!!....Which are around 240cc
Paul.
MY BLOG - http://westfieldv8.blogspot.co.uk/
|
|
|
