Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: External EFI fuel pump question
Alan B

posted on 28/11/10 at 01:28 PM Reply With Quote
External EFI fuel pump question

After my in-tank (Honda Civic) fuel pump ceased working I replaced it with an external Summit racing unit. At first all seemed well...started up fine...ran well....but it's very noisy. I don't just mean a consistent, but loud pumping noise, but also other strange noises, also it gets quite hot. This alone wouldn't cause me too much grief if it was normal, but to make matters worse it acts like it's not keeping up, stalling a couple of times just while idling. One time it stopped completely having blown a 20A fuse on the main power supply.

Any ideas?....some fundamental problem of my doing?.....dodgy pump?

Cheers,

Alan

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
tomgregory2000

posted on 28/11/10 at 03:19 PM Reply With Quote
Sounds like a dodgy pump to me, i have a bosch 044 external pump fitted and its a noisey whine that varies depending on load on the pump
View User's Profile View All Posts By User U2U Member
ko_racer

posted on 28/11/10 at 03:58 PM Reply With Quote
I'd also check the current rating on the fuel pump. I know the 044 needs up to 30A, so you may need to run a seperate supply and relayfor the external pump.

They are noisy too, but can be rubber miunted to reduce it abit

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
atspeed racing

posted on 7/12/10 at 12:00 PM Reply With Quote
assuming the pump is/was fine.

check your install, sounds like cavitation problems to me if its getting hot. the pumps dont last long if they are not sucking up fuel and WILL make a lot of noise and get hot. they may also be ok until the fuel demand gets greater, e.g. fne at idle, but problem occurs once you start driving or go around a corner.

external EFI pumps do not suck up fuel well, but they pump lots. they ideally need a large volume of fuel on the back of the pump, and large diameter pipe going into it (AN - 8 / 10mm for example) and either below fuel tank, or below a swirl pot.

here is my fuel install in my pug 106.



bmw m3 in tank pump (i recommend a walbro 255 as an intank pump)
fills the swirl pot (pre filtered) -8 fitting to the 044, to the engine via -6 (filtered) and return to the pot and tank in -6.
volume of fuel in the swirl pot keeps weight on the back of the pump, so no cavitation occurs.

- colin.

NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.