Project7
|
| posted on 1/3/06 at 07:52 PM |
|
|
Injector Flow Rates
Hi,
I have a set of Injectors from a Rover 2.0 T Series engine with the flowing numbers
03183GB
MJY10029
2237
Does anybody know the flow rate for this type.
Thanks
Tony
|
|
|
|
|
Project7
|
| posted on 1/3/06 at 08:14 PM |
|
|
Cheers Mark, but i checked that web site already and couldnt find anything that matched up. 
Might just end up guessing the flow rate based on the BHP the T series produced????
|
|
|
britishtrident
|
| posted on 1/3/06 at 08:29 PM |
|
|
According to the Rover 820 parts list the same injectors were used on Turbo and normally aspirated Rover T16s ---- that means they should be good
for bit over 200bhp.
|
|
|
Project7
|
| posted on 1/3/06 at 08:46 PM |
|
|
quote:
Originally posted by britishtrident
they should be good for bit over 200bhp.
Cheers - thats surprising - probably means they're be abit OTT for my 1.6 zetec though.....
[Edited on 1/3/06 by Project7]
|
|
|
britishtrident
|
| posted on 1/3/06 at 09:11 PM |
|
|
quote:
Originally posted by Project7
quote:
Originally posted by britishtrident
they should be good for bit over 200bhp.
Cheers - thats surprising - probably means they're be abit OTT for my 1.6 zetec though.....
[Edited on 1/3/06 by Project7]
It should be OK the standard non-turbo 820 kicked our 138ps a warm 1.6 Zetec shouldn't be that far off. I am pretty sure the Turbos ran a 4
bar fuel presure and the non Turbo 3 bar.
|
|
|
Project7
|
| posted on 3/3/06 at 10:35 AM |
|
|
Ok, i'll try them and see how they go -thanks for your help 
|
|
|
