Steve Lovelock
|
| posted on 25/10/07 at 08:01 AM |
|
|
MSnSE setting up help required in North London
Hi,
I have built an MSnSE unit with a wasted spark set-up and successfully tested it. I have built a relay board and the interconnecting cable. I have
got a Vauxhall 2.0 16V XE engine into my car. I have modified a manifold and fitted a set of GSXR TBs. I have purchased an LC1. All sensors are
retained from the original setup. I have fitted a coil pack from another Vauchall engine. I have fitted a Denso alternator. I have successfully
fitted a Vicki Green loom and got the ancillaries working.
Now all I need to do is source an oil-cooler, configure the MSnSE & LC1 for my engine, set the sensors up and start the thing. Yet every time I
look at the various MS manuals it all goes in through my eyes and out of my ears without registering in between. I was ok with the build manual
because I did exactly as I was told but I am finding the set up manuals to variable to get my head round. Whilst not quite being Albert Einstein I am
not daft either.
So, I don't suppose there is anybody vaguely near North London who could lend me a few hours and help me configure the beast? Or if it is
something that can be done away from the car I could and would gladly come to you with the box of tricks and my laptop.
Yours hopefully
Steve 'I really want to start my car so that I can finish it for the spring' Lovelock
|
|
|
|
|
chriscook
|
| posted on 25/10/07 at 06:55 PM |
|
|
U2U me at the weekend and I'll send you my msq with some info - but they are for MS2Extra
I'd still suggest you really try to get your head around the setup and any setup you get of someone will need adjustment.
|
|
|
