yellow melos
|
| posted on 8/2/09 at 09:33 PM |
|
|
Fuel Pipe ID
I have a dilema, the in side of the fuel pump is 12mm ID but the hose from the tank is only 7-8mm, will this case the pump to strain of the flow from
the tank is not great enough ?
It's an injection pump with upto 7 bar pressure
|
|
|
|
|
theconrodkid
|
| posted on 8/2/09 at 10:03 PM |
|
|
its what i,m using,seems to cope ok
who cares who wins
pass the pork pies
|
|
|
Chippy
|
| posted on 8/2/09 at 10:59 PM |
|
|
As Conrod says, will be fine, mine is fed by 8mm copper tube. HTH Ray
To make a car go faster, just add lightness. Colin Chapman - OR - fit a bigger engine. Chippy
|
|
|
yellow melos
|
| posted on 8/2/09 at 11:08 PM |
|
|
Cheers,
i had read simlar on an old forum for an xr4i car, but they were still building so i don't know what happened !!!
|
|
|
hughpinder
|
| posted on 9/2/09 at 08:51 AM |
|
|
6.4 bore tube will flow enough for 300 bhp at 3 bar - how powerful is your engine going to be?
|
|
|
yellow melos
|
| posted on 9/2/09 at 10:47 AM |
|
|
Running about BHP 120ish, but most of the fuel is returned to the tank anyway
|
|
|
