Ghost Dog
|
| posted on 15/2/09 at 12:04 PM |
|
|
MicroSquirt / EDIS 4 wiring & Setup
Can anyone help with the MicroSquirt / EDIS set up?
I have looked at most the manauls for the system and I just want to check if the following set up is correct for EDIS on MicroSquirt:-
1: Change Jumpers JP5 & J6 to Ignition Logic Level Output (I understand that this gives a 0-5Vdc output on MicroSquirt Pins 11 & 12 -
Ignition outputs 1&2 for EDIS SAW connection).
2: EDIS PIP connection goes to PIN30 or 31 on the MicroSquirt.
3:Set ignition spark mode to EDIS.
Any information or comments would be appreciated.
Many Thanks,
Mark.
|
|
|
|
|
theconrodkid
|
| posted on 15/2/09 at 01:24 PM |
|
|
http://www.msextra.com/manuals/MS_Extra_Ignition_Hardware_Manual.htm#edis
have a look at this site,its the most helpful imho
who cares who wins
pass the pork pies
|
|
|
Ghost Dog
|
| posted on 15/2/09 at 07:38 PM |
|
|
Thanks for the Link Conrodkid, printed off most the manuals for the the MegaSquirt then I realised the connections on the MicroSquirt are a total
diffrent layout with less of them. I have read that much now I have information overload. Looking at all the manuals along with this thread:-
http://www.microsquirt.com/viewtopic.php?f=87&t=23064&p=147110&hilit=edis#p147110
I am guessing the logic ignition settings on the MicroSquirt make the ignition outputs # 1&2 (ECU connections 11&12)0-5vdc square wave rather
than 12vdc which the EDIS SAW connection is connected.
I am also thinking that the EDIS PIP connection goes to (ECU connection 30) OPTOIN+ on the MicroSquirt.
Just not 100% at the moment and I don't want to fry anything....
Many thanks.
|
|
|
