darrens
|
| posted on 13/4/10 at 02:02 PM |
|
|
Bosch Fuel Pump
I have a Bosch fuel pump (0580 464 029) which has given up the ghost.
This I need to replace, however I can't find the same one (nor can I determine it's actual flowrate)
If I change this for a different model will this require re-mapping the tables in MS or will the fuel rail regulator accommodate this.
Any help appreciated.
Regards
|
|
|
|
|
flak monkey
|
| posted on 13/4/10 at 02:03 PM |
|
|
No remapping required as long as the pressure is the same 
All bosch pumps are the same external dims, although pipe connections may be different.
Sera
http://www.motosera.com
|
|
|
BenB
|
| posted on 13/4/10 at 02:35 PM |
|
|
As said no re-mapping is necessary. The max flow rate of your new pump will need to meet the fuel requirements of your engine. Best options is to go
for a fuel pump from a N/A EFi car with a similar amount of BHP...
|
|
|
Agriv8
|
| posted on 13/4/10 at 02:49 PM |
|
|
sounds like you need the Fuel pump for a 3.9 TVR unsure of the numbers but reasnobally sure they were inline bosch.
regards
Agriv8
Taller than your average Guy !
Management is like a tree of monkeys. - Those at the top look down and see a tree full of smiling faces. BUT Those at the bottom look up and see a
tree full of a*seholes .............
|
|
|
darrens
|
| posted on 13/4/10 at 03:01 PM |
|
|
I got this off a car in the breakers, was a v8 but can't for the life of me remember what car it was.
Could do with finding out the flowrate of the broken one
[Edited on 13/4/10 by darrens]
|
|
|
