andylancaster3000
|
| posted on 8/4/11 at 10:02 AM |
|
|
12mm ID 180deg Fuel Pipe?
Anyone know if 12mm ID preformed 180degree bends in some form of flexible pipe suitable for (low pressure) fuel is commercially available? I could
just about get the radius I need without any kinking with straight pipe but would prefer not too. I'd also prefer to not do it with multiple
bits of flexible pipe and rigid bends to save on a few failure modes and possible leak points!
If so, anyone know where I can get it from?
Cheers
Andy
|
|
|
|
|
deezee
|
| posted on 8/4/11 at 10:19 AM |
|
|
Is forming the bend out of copper pipe a possibility? Does it have to be a tight turn?
|
|
|
