big-vee-twin
|
| posted on 4/1/12 at 06:28 PM |
|
|
Duratec Crank Sensor Tool
Does anyone have a Duratec crank sensor alignment tool that I could borrow and send back, and a little guidance how to use?
Many Thanks
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
|
|
Doofus
|
| posted on 4/1/12 at 07:39 PM |
|
|
Just start it up, put a timing light on and move it by hand to get the timing spot on.
|
|
|
pjay
|
| posted on 4/1/12 at 08:03 PM |
|
|
You could also get it about right by eye and then adjust using MegaTune's 'Trigger Wizard'.
If you do manage to get the jig the following shows how to use it:
 
Description
|
|
|
dave r
|
| posted on 4/1/12 at 09:14 PM |
|
|
unless you are going to remove and replace it at a later date, it dont really matter.....
not as though you are trying to run it on the standard map
I'd love to give my imaginary friend a great big hug,
but this jacket makes it impossible.
|
|
|
britishtrident
|
| posted on 4/1/12 at 09:25 PM |
|
|
Old trick is before removing the old one use a quick spray with aerosol paint to create an outline witness mark on the block, then fit the new one
so it stays within the marks outline.
[I] “ What use our work, Bennet, if we cannot care for those we love? .”
― From BBC TV/Amazon's Ripper Street.
[/I]
|
|
|
