thepest
|
posted on 5/11/10 at 02:11 PM |
|
|
Zetec SE injectors
Anyone know what the size of these injectors are? Engine is from a 1996 ford fiesta and is 1250 cc?
Also are they high or low impedance injectors?
Cheers & thanks
|
|
|
Madinventions
|
posted on 5/11/10 at 03:23 PM |
|
|
I don't know the flow rates unfortunately, but mine measure about 11 ohms each, so they're low impedance.
Good little engines by the way!
Ed.
Mojo build diary: http://www.madinventions.co.uk
Solo music project: Syrrenfor http://www.reverbnation.com/syrrenfor
View my band website:
http://www.shadowlight.org.uk
http://www.eastangliankitcars.co.uk/
|
|
will121
|
posted on 5/11/10 at 05:26 PM |
|
|
are they the side fed ones, if so what colour? the brown 97MF-BA 1.4 fiesta ment to have a flow rate of 135cc/min so 1.25 would say this or less, also
15.7 ohm which i think is high impedance
[Edited on 5/11/10 by will121]
|
|
big_wasa
|
posted on 5/11/10 at 05:56 PM |
|
|
At 11 ohms they are high (z) you would be measuring 2~4 ohms for low Z
|
|
beaver34
|
posted on 5/11/10 at 07:22 PM |
|
|
anyone know what other injectors will fit in place of the stock ones
|
|
will121
|
posted on 5/11/10 at 08:51 PM |
|
|
are they side fed ones like this?
if so and can measure them i will check they are the same as 1600Si ones if so these should fit as replacements
RS1800 XR2i
Part number - Bosch 0280155503
Flow rate - c190cc/min at 3bar
Mondeo 2litre
Part number - Ford 948F-B2B (beige)
Flow rate - c225cc/min at 3bar
RS2000
Part number - Bosch 0280155504
Flow rate - c250cc/min at 3bar
1600 Zetec
Part number - Ford 948F-AB / 948F-A2A (black) / 567 31 2471
Flow rate - c150cc/min at 3bar
|
|
beaver34
|
posted on 6/11/10 at 08:26 AM |
|
|
no not side feed, ill get a pic of them up
|
|
thepest
|
posted on 6/11/10 at 10:24 AM |
|
|
They are not side fed, I'll get a photo sorted out & posted.
Thanks for the info everyone
Does anyone have reference to a haynes ford fiesta manual 1995-2002? I'm guessing that such info could be found in there... am I right?
|
|
beaver34
|
posted on 6/11/10 at 11:11 AM |
|
|
thanks saves me getting a pic, i need some injectors that will flow enough for 300bhp
|
|