piddy
|
| posted on 25/3/06 at 09:45 AM |
|
|
Edis 4
Hello all I'm at the wiring stage and was wondering, what wires are used from the EDIS when using a Mega Squirt?
I presume Live,Earth,SAW and PIP signal.
But what else?
A wiring diagram would be good.
|
|
|
|
|
Chris_G
|
| posted on 25/3/06 at 10:33 AM |
|
|
Here you go piddy....
 
Rescued attachment edis4wiring.gif
Now finished! Xflow-Zetec swap with GSXR TB's and Megasquirt.
|
|
|
Chris_G
|
| posted on 25/3/06 at 10:35 AM |
|
|
Plenty of reading HERE too 
Chris
Now finished! Xflow-Zetec swap with GSXR TB's and Megasquirt.
|
|
|
piddy
|
| posted on 25/3/06 at 06:14 PM |
|
|
Thanks Chris.
Do you know wheere I can buy the connection plug to fit the coil pack?
|
|
|
Chris_G
|
| posted on 26/3/06 at 12:41 AM |
|
|
I got one by posting a wanted thread on this forum, otherwise the scrappies are probably the best bet.
Chris
Now finished! Xflow-Zetec swap with GSXR TB's and Megasquirt.
|
|
|
piddy
|
| posted on 26/3/06 at 06:02 PM |
|
|
I've been told from a member of the Mega squirt forum that this diagram is incorrect! pin 10 should go to coilpack 1 and pin 12 to coilpack 3.
Anyone esle found this to be the case.
|
|
|
MikeRJ
|
| posted on 27/3/06 at 03:36 PM |
|
|
quote:
Originally posted by piddy
I've been told from a member of the Mega squirt forum that this diagram is incorrect! pin 10 should go to coilpack 1 and pin 12 to coilpack 3.
Anyone esle found this to be the case.
It's not hugely important, if it is wrong it just means your HT leads would need to be swapped between the two coils.
|
|
|
