Hi all,

just tested my car again
i'm not sure about the powercommander on my zx12 (wired by the previous owner)

is there a good manual for operating this PCIII?!

is it correct that only the bottom led burns in normal use?

as indicated by the arrow below...?

Description


koen

i hope this helps you sort things good luck paul http://66.132.187.150/powercommander_iii_usb/powercommander_general_downloads.aspx

[Edited on 10/4/07 by imp paul]

I believe in normal use this is the position of the throttle position. At its lowest position it's idling.
When tuning its function changes... of course I'm only familiar with ours which is slightly different!

Steve

Hellfire is correct default display is throttle position

thx

koen

today I calibrated the throttleposition sensor to the PCIII using the serial cable&software.
now the leds are OK ( moving along similar to the throttle pedal)

:-)

koen

IMP PAUL Love your imp looks great been looking through your archive and just curious we you fitted the sierra diff when you could have went for a chain and sprocket set up.