As title. Need a new one for the lower joint on the front upright. I can't find one anywhere!!

Thanks for any help.

Why are you trying to mix metric and imperial?

I have not seen metric rod ends with the threaded shank bigger than the bore.
I have used imperial rod ends such as 5/8" bore 3/4" UNF shank.

If you need a 3/4"UNF male shank for the lower wishbone and need a 12mm bore for the bolt to the bottom of the upright then use a 5/8" x 3/4"UNF rod end and fit reducing spacers to 12mm ID.
McGill

[Edited on 11/9/12 by minitici]

Thanks for that thinking it might not be M12 then

Here is a pic of mine (standard RAW fitting).

https://m.facebook.com/shaun.d.kemp?v=photos&__user=739528373#!/photo.php?fbid=10151140521493374&id=739528373&set=a.10151083626438374.4512 79.739528373&__user=739528373

Think it must be from a road car rather than a generic fit due to the shape?

Just has a look at your photo and now realise that you were asking about a ball joint rather than a rod end joint

The pin into the upright will be a taper pin - no doubt it is a readily available joint.

Given up looking and went to RAW. £18 delivered may not be the cheapest but it fixes the car so I'm happy