Ey up,

Just reading up about EDIS and megajolt wiring, on the autosportlabs vehicle installation guide it says to use 12-14 gauge wire. What does this mean in english?

CLICK

Its about halfway down this page.

ta

Standard wire gauge

Link

If you need any wire / plugs / help give me a shout mate.

ta muchly! quick to pounce there mate!

were you doing a delivery to market deeping monday? i was just coming out of frognal area when a tanker zipped by.

Make sure you use the sheilded wire in the right place and properly earthed.
Trigger Wheel .com do the stuff and you can find it in Maplins.
I had a lot of problems with the plug on the VR sensor so make sure it is properly connected and secure it against vibration and cable pull.

Yeh could be by zip by you mean 40mph

cheers snapper

yeh wasa tanker going slow but i was making fair progress in a works truck!

So you reckon somthing like ref 25 on this page?

link

I used leads removed from the 'donor' for the crank position and tps. For plug into the edis i used wire that came with it. For the wire to the MJLT itself i used the wire of a computer power supply which i got the plug off. Swapping the wires around so the thick ones become the current carrying ones and the colours made sense. Then used some cut up loom from a 306 for odd other bits.

Total cost = very low! Time taken = not much.


Daniel