Board logo

Wiring Advice
FrankP - 26/2/10 at 06:35 PM

I think I am on the downhill stretch for I am aiming to to the IVA at the end of April (when should I apply for the test?)..

I have been looking over the wiring. In the engine bay I have covered the wiring with with split conduit or tape.

I do have a wire that runs from the fuel pump to the dash. This is not covered in tape or plastic conduit. I have cable tied it to the loom so it is quite secure and not near anything hot. Am I going to have to get this covered??

Thanks

Frank

eddie99 - 26/2/10 at 06:39 PM

I'd get some cheap tape and spiral tape it onto the loom just to be certain!

tomgregory2000 - 26/2/10 at 06:47 PM

Yep cover it

I failed sva on wire that was not covered and other things

britishtrident - 26/2/10 at 07:46 PM

You can get small dia split conduit for single wires.

eddie99 - 26/2/10 at 08:55 PM

quote:
Originally posted by britishtrident
You can get small dia split conduit for single wires.


You can, but personally i think it'd look quite messy having your loom and then a single wire down a split sleeving.

plantman - 26/2/10 at 09:33 PM

polevolt.co.uk