Question...

I started with a Pinto that used the ESC2 engine management system and weber 30/34 DFTH carb where the engine coolant temp sender is located in the inlet manifold.

I have now changed the inlet manifold and carb for a setup from a Capri with a 32/36DGV carb, but the coolant temp sender was fitted in the cylibder head on that engine.

How can a I get a coolant temp sender fitted???

Cheers

Nick

on the head i have it just screws into the head beside inlet port on no1 small brass thing have one spare if you want it!

The ford temp sender for pintos will only match/work if you are using the ford dash/pod.

You may need to contact suplier of seperate clocks or dials to match the gauge to the sender.

I had this problem with my racetech temp gauge,rally design or merlin motorsport can supply.

[Edited on 8/5/04 by bob]