Morning Guys,
I have a 1.8 blacktop from a mondeo, does anyone know if the sensor from an acewell will fit into the thermostat housing. IIRC the sensor in the bottom is for the guage and the one on the top is for the ECU?

Cheers Jas

mine fitted from an acewell 3994 into bottom of thermostat housing on 2.0 slivertop

Yep 1/8 npt thread on the bottom. Mine is there

Beauty! Cheers guys!

The sensors normally sent out with Acewells up until now have been M10 x 1.0, however this is so close to 1/8 x 27 NPT that providing you use a bit of thread tape because it's a tapered thread they will go in & seal perfectly. I've been told that from the next batch onwards they'll be sent with the 1/8 27 npt thread as standard - I've been told that b4 tho'!

Cheers Russ!