LocostBuilders - powered by XMB

Fitting an Immobilizer to a 919 Fireblade

IainL - 3/8/11 at 04:37 PM

I have just brought a Sterling Touch immobilizer to keep Mr IVA happy.

I have found a cricuit diagramme on here so I now know what the wires are, but could someone confirm which wires I need to break into on my 919 Fireblade engine to fit the immoblizer wires too.

Thanks,
Iain

big_wasa - 3/8/11 at 04:53 PM

If you have a steering lock and ignition from a sierra you wont need the imob' for ive.

Pick any two circuits. I would do starter relay and fuel pump relay Or fuel pump relay and feed to the ignition coil.

[Edited on 3/8/11 by big_wasa]

wylliezx9r - 3/8/11 at 09:07 PM

I was reading the iva manual today and as long as you have a steering lock an immoboliser isn't required. After the immobiliser going tits up on my old zx10r I wont be fitting another if I can help it.