just turned my engine over and im getting no crank signal

its omex 600 using stock ford crank sensor that worked fine before, the setting in the ecu are a base map from omex

ive changed the mx timing either way but to no avail, how do i check the sensor is wired correctly?

thanks

someone on here the other week had the same issues... turned out the supplied loom was wrong


click me

[Edited on 8/4/12 by dave r]

thank, ill check the loom but im 99% its right as i have run it last year

how do i check for continuity of the wiring?

fixed, was connector on the end was not a genuine ford one and did not clip on correctly, now just need a fuel pump then should fire up