My problem is - hazards work fine with ignition off. When I switch ignition on the hazards are on. If I remove the hazard switch I still have the problem, but when I disconnect wiring from sierra indictors stalk hazards work fine with/without ignition on. I'm using a tiger supplied loom and digidash2 lite.
Anyone come across this problem?

[Edited on 30/4/14 by neilp1]

Sounds like your feeding switched live back into the hazard circuit somewhere. I used a diode to fix my problem but I knew where the leak was.

I think you will need a diode but it's just finding where to put it

I had a similar but not exactly same problem, indicator stalk was the culprit.

All fixed now. I had wired the telltale wiring straight to digidash. Once I added the telltale warning lights and a feed off them it worked fine!