hi

I've got this pic from the cbr600rr3 manual, the wire colours match the one from the cbr600rr4 TPS I have, so I am going with they are the same.

Can anyone advise which is ground, constant and signal? (wiring up to megasquirt)

thanks


cbr600rr3_TPS

[Edited on 17/1/15 by Chris_Xtreme]

R/y is signal and then g/o is 0v, y/r is positive I believe. If the last 2 end up arse backwards (ecu is seeing full throttle when it is closed) then you can swap the 0v and 5v.

Nice, thanks for the info. Going to use a connector block until tested.

Cheers fellow xtreme owner

worked a treat

Perfect, I have been taking my time over getting my nodiz in and running but will have to cross the tps bridge at some point too.