Had to move the scuttle around this morning whilst getting to the throttle pedal. I have now put it all together and the indicators do not work now (but hazards does), not does the dipped and main beams, (but side lights work). I expect that a wire has come loose, but just in case, is there any way to test the indicator relay or the lights relay? Or any thoughts were to start looking?

Cheers
Craig

[Edited on 24/5/15 by aka Keith]

Sides and hazard will be on a permanent feed whereas the indicators, main and full are switch normally via a relay.

I'd check the live to the relay and then make sure its fully home and operational.

Having all 3 switched items off points to that area.

Good luck,
Steve

Cheers Steve,

I will try and have a look later today.

Cheers
Craig

Given that the indicators (but not hazards) and high/low beam go through the left hand switch it sound as if you have just pulled the plug out of the switch. I'm assuming it's a Sierra switch

Thanks Gaz, simple. found a connector that had puled apart under the dash. simple plug and back they work again.

Cheers
Craig