Hi
Got a project, it had already been working but the wiring was a mess.
Since rebuilding the car I have no an issue with what wires do what.
Loom has been adapted already but I am a little lost.

What would be power into the ecu? Orange/white?

Yellow/green, go to earth?

Black/green...no idea on this one.

Starter is wired independent from the engine loom so I can turn it over but need to sort the ecu side of it.

Hoping someone on here has the knowledge.

Cheers guys

yellow green is not earth defo black is

but !
depends on year of loom
uk or usa
what about the neutral and clutch switch ?
is the alarm plug wiring still there
if it a later loom be careful as there are black live wires as well, and black indicator wires.

some pics might help and more info

any help?
http://www.team-moto.com/HayabusaWireHarness.jpg

I have a diagram, which I think is correct one but still a bit lost.

Loom has been stripped back by previous owner so prob got a max of 9 wires left loose.

Neutral is blue and is working.

Yellow/green I though I had read somewhere to earth to act as clutch switch bypass...left loose for the min.

Orange/white I have as ignition live.

Not sure which should feed the switch side of my fuel pump relay.

Black/green I have left loose as no idea on that one.

Orange/yellow (from memory) is earthed via a 100k resistor

Just looked and these are the only wires I have that need connecting by the looks for the engine loom.
Orange/Yellow (have 100k resistor to earth)
Yellow/blue (tacho)
Blue (neutral light)
Yellow/green
Orange/white
Black/green
Black/yellow

Tip over switch is in place still.

Hopefully someone can help