Board logo

Megajolt
dave1888 - 12/9/05 at 04:20 PM

The Zetec crank position sensor picks up TDC from the flywheel, can you use this set up for Megajolt, or do you need to fit a 36 toothed wheel setup

paulf - 12/9/05 at 05:17 PM

Yes just use the original flywheel trigger, a toothed wheel is only required on older engines or other makes.
Paul.

dave1888 - 12/9/05 at 07:02 PM

Have you by any chance got a list of components to make up the ver 3 board yet Paul

paulf - 12/9/05 at 09:16 PM

Theres a printable list on the megajolt site, everything is available from farnells or RS.I havent made an ordering list up yet, as I need to sort what parts ive got and then order parts for 6 units.
I can flash the chip with the bootloader if you need one.
Paul

quote:
Originally posted by dave1888
Have you by any chance got a list of components to make up the ver 3 board yet Paul

MikeRJ - 14/9/05 at 12:17 PM

quote:
Originally posted by paulf
Yes just use the original flywheel trigger, a toothed wheel is only required on older engines or other makes.
Paul.


As long as the flywheel trigger has 36-1 teeth!

dave1888 - 14/9/05 at 08:07 PM

I ordered the chip at the same time as the board.