Has anyone used Lowtension lately?
Tried to ring no reply.
There E bay shop is empty.
There web site changed.
Gone bust maybe? I hope not.

Hi,

I'm also trying to contact Lowtension. Have you some news?

I'm looking for a sender for my electronic vdo speedometer ... I need the sender, wires, wiring diagram, and instructions for the calibration ... and an "outer threaded retaining ring" for a vdo tacho.

Can somebody help?

I'm in the same boat, also trying to get through to Lowtension, tried email, phone and website with no luck.
I need wiring diagram for VDO revcounter too. Can anyone out there help, please?

[Edited on 3/12/05 by Spriggsy]

I've got the VDO wiring diagrams. I'll try and post them in my archive.

Syd.

Give me an email address and I'll send them as an attachment.


Edit...5/12 Info has been sent to flakmonkey's site, hopefully it will appear soon.


[Edited on 5/12/05 by Syd Bridge]

Hey guys.

The instructions and info for the VDO gauges can be accessed from the downloads section of my site, or from this link:

http://gtslocost.locostsites.co.uk/vdo_gauges_info.pdf

Cheers,
David

Thanks lads, much appreciated

I've just had a look at the link, I still can't see the wiring diagram for the rev counter?
I know its only got 3 pins-positive, earth and signal- but if I wire it up wrong I may pop the electronics

Thanks for any help that can be offered.

[Edited on 5/12/05 by Spriggsy]

OK Tacho stuff is not in there.

I'll do a drawing and send it on as a pdf.

You have three very small dip switches to set as well, depending on the number of cylinders.

Syd. (without the . )

Cheers Syd, much appreciated. Those switches were going to be my next question!