As the title says, whats the best way to attach my Premier loom to the wires from the column switches.
Is it just a case of splicing them together using suitably rated spade connecters ?

TIA
Richyo

the best way to wire anything that your planning on not really messing with again

is to solder and use heat shrink

much neater and less crap everywhere

chris

Yep solder and heat shrink if your not planning to have it off again.

You can twist it all together to make sure it works ok then solder afterwards. Much neater.

Soldering also suffers less from corosion problems unlike crimp connectors.

If you do wish to beable to unplug then get an apropreate multi way plug then you can unplug all in one go much tidier

A bit late now but Premier will attach Sierra multi plugs to the loom if you send them the multiplugs from your donor with the order , also you need to tell them which switch's you are using . Anyone thinking of using one of their looms take note