Board logo

Edis 4
piddy - 25/3/06 at 09:45 AM

Hello all I'm at the wiring stage and was wondering, what wires are used from the EDIS when using a Mega Squirt?

I presume Live,Earth,SAW and PIP signal.
But what else?

A wiring diagram would be good.

Chris_G - 25/3/06 at 10:33 AM

Here you go piddy.... Rescued attachment edis4wiring.gif
Rescued attachment edis4wiring.gif

Chris_G - 25/3/06 at 10:35 AM

Plenty of reading HERE too

Chris

piddy - 25/3/06 at 06:14 PM

Thanks Chris.

Do you know wheere I can buy the connection plug to fit the coil pack?

Chris_G - 26/3/06 at 12:41 AM

I got one by posting a wanted thread on this forum, otherwise the scrappies are probably the best bet.

Chris

piddy - 26/3/06 at 06:02 PM

I've been told from a member of the Mega squirt forum that this diagram is incorrect! pin 10 should go to coilpack 1 and pin 12 to coilpack 3. Anyone esle found this to be the case.

MikeRJ - 27/3/06 at 03:36 PM

quote:
Originally posted by piddy
I've been told from a member of the Mega squirt forum that this diagram is incorrect! pin 10 should go to coilpack 1 and pin 12 to coilpack 3. Anyone esle found this to be the case.


It's not hugely important, if it is wrong it just means your HT leads would need to be swapped between the two coils.