Just got a V2 board which is set up for MAP.





Can i convert this for use with TPS? If so, how?

Many thnaks for any advice,

Iain

You can convert it by removing the MAP sensor and connecting the +5v connection to one end of the Throttle pot , connect the other end of the pot to neutral and the wiper connection of the pot [signal ] to the output pin position of the MAP sensor.use sheilded cable and feed through a hole in the case.
I wil find a diagram later on when I have time .
Paul.

pins as looking at your picture

1 Wiper on TPS
2 Ground
3 +5v
4 n/c
5 n/c
6 n/c


HTH

Ray