After almost deafening myself with the first start of my engine (I really should get an exhaust made!), I now need to tidy up the butchered wiring.

I have started routing the main EFI wiring around the engine bay and need to tape it all together soon. However, I was wondering how everyone takes the multiple feeds from the ignition switch to the coil / fuel relays / ignition module, etc?
Is it usual practive to just solder it all into one clump or do people usually feed these to a busbar on a fuse box for neatness?

I also guess connector blocks are out as far as Mr SVA is concerned??

There are several methods - loom tape, spiral wrap or my preference, heatshrink tubing.