I'm looking at getting one of the large pushbutton savage starter switches but have a question first.

The pics of it I've seen show 6 connectors at the back.
I'm guessing that this has a relay built in.

Does anyone know if it can be used as a simple push to make as my start circuit needs to join 2 low current wires to start the engine.

Fairly certain it can if it's like mine.

Steve

Hi, thats how ours is wired, I don't believe it is a relay but a double switch instead where it can be used to switch two seperate circuits at one time keeping them both seperate. If you look carefully on the side IIRC there is a diagram labeling the pins 123 123 one set for each side.

Again IIRC you just need to use one side ie 1 set of 123 and connect your two wires to 1 and 2. If that doesn't work its the other way around ie 1 and 3.


HTH


Ed

[Edited on 5/9/06 by esn163]

This might help, shows how I wired mine, pins 1 & 2, illumination on + & -

http://www.dewweb.co.uk/indyblade/images/Indyblade_wiring_v17.pdf

HTH,
Rich.