I've done lots of searching on this so I know it's a re-occurring question and I've got some helpful stuff but I'm still stuck on how to start. Basically I've got Sierra stalks with there plugs and wiring and I'm connecting to a ZX9 loom. I think I'm half understanding but will I need some kind of hazard flasher relay or just a standard flasher relay from Halfords. I've an indicator relay already on the loom can I use this in some way.
Cheers in advance. I know this is a common question.

If you have the sierra switch and the sierra relay it will do the lot.

I split it out of the sierra loom and got it running with a perm +12v for tha hazards and a switched +12v for the indicators plus an earth.

So I need a Sierra relay then? Is it called a flasher relay or a hazard relay?

as found behind the dash on any sieera.

I can work out a wiring diagram if needed.

Just read about the bike loom. That I can not help you with. But you could still use the sierra bits to do it instead if nobody gives you any other ideas.

[Edited on 17/2/08 by big_wasa]

No thats great mate. I got a good idea from a sketch in Steve Gustersons archive I should get it from there. Like I said I just didn't know where to start really. Grateful for that mate. cheers

I used the relay from the ZX9R loom, worked Ok for me.

Cheers

Ian

black is ignition switch live, red is perm live.

there are two wires that feed the bulbs Black/ white trace and Black/ green trace one is left and one is right.( I didnt check which was which).


All other colours as seen at the plugs.

very easy to splice into any loom.

Any help ?

the ford relay will need to see a load of 21W+21W + (side repeater)each side to run

[Edited on 17/2/08 by big_wasa]