hi i have a fazer 1000 same as r1 on carbs have wired up but it will not start
i think it is fault with starter relay cut off
i have by passed clutch and side stand and the kill switch
but when i join the to black wires together to close off the cut of relay nothing happens
if you earth the starter relay with the 4 pin plug and the battery and to motor connection it will turn over
do you think this is a fault with the cut off relay and could i just fit a 2nd relay instead of having to get a new one
the relay in question is this one

thanksImage deleted by owner

Have you by-passed the clutch, side-stand and neutral (or is it in neutral) switches?

adrian

have done clutch and side stand do you have to do any thing with the neutral switch
mark

Check the gearbox is in neutral and try again

have you checked the tilt switch?

Make sure it is in neutral. Put the handbrake on. Short the blue + white wire from the starter relay to ground for a couple of seconds. The starter motor should turn. If it does, your shorting of the clutch switch etc is the problem.

i have just checked the neutral switch and it is doing nothing witch way should it switch when in neutral should i get a earth or +
thanks mark

When in neutral it goes to earth. Short the wire to earth and see if it starts.

adrian

have done that still nothing any more thoughts are very welcome