Board logo

can these be used for reverse light & side lights?
blakep82 - 13/9/08 at 08:51 AM

http://www.cbsonline.co.uk/all-purpose-white-led-strip-lamp-apled-3446-p.asp

quite like the minimalist look, but don't seem to be e marked. they do have e marked ones for £22 a pair, but i don't like the housing's they're in


BenB - 13/9/08 at 09:18 AM

I doubt Mr SVA man would like it.... I'd fit some bog standard ones in such a way that you can fit those afterwards....


matt_claydon - 13/9/08 at 09:23 AM

Lights do not have to be e-marked so I don't see a problem. Reverse lights are not even a tested item so definitely no problem there.


BenB - 13/9/08 at 09:40 AM

Lights don't *have* to be e-marked but if they are not e-marked they have to be deemed "equivalent" by the tester. In my experience they dislike anything that isn't E-marked (cos they failed my fog light which was brighter than the E-marked one I replaced it with and they were happy with).....


blakep82 - 13/9/08 at 09:45 AM

both very good points.
replace after it is then. except the reverse light maybe. perhaps i'll just not have one to start with.
cheers guys!


matt_claydon - 13/9/08 at 09:47 AM

With a non e-marked fog lamp the tester has to make a judgement as to whether it has a brightness of at least 150 candelas (not easy, so he's probably going to err on the side of caution).

With side lamps brightness is not an issue so I wouldn't have thought they would have any reason for complaint (unless they are excessively bright and liable to dazzle).