3 pins on this in the plug of the reservoir, how do I wire it in to my loom/ the brake warning light?


res sender 3 pins

Do I need a special plug or can I just run off of one or all these conections?

Ta

Nath

If I recall correctly it just connects the two outer contacts. You can check by measuring resistance on the two and pressing the button on top.

Mine is only wired with 2 of the connectors - im sure its the outer 2.

If you dont have the Ford plug you should be able to get female spade connectors to fit.

This is how I did mine:


Circuit diagram

I am using two sensors (two resevoirs). the circuit starts with a 12v supply, and ends when it goes to ground....

^^^ 4.7 mm spades will fit.

it has been posted before so search; if you struggle I cna take a look.

but from memory, two of the contacts are common - it allows you to wire the handbrake switch to the cap.

the purple circles are the 3 terminals on the cap. you need to figure out what is connected to what!
Rescued attachment brake_sw.JPG

ta lads, easy as pie!

Or this.
Rescued attachment lowbrakefluid.jpg