karlak
|
| posted on 20/10/09 at 07:20 AM |
|
|
Sierra Indicator stalk
Have a slight problem with Indicators. The stalk has 2 positions, the first is temporary hold for quick couple of flashes etc, but then the second
position is the constant on (and indicating mode). In position 1 the indicators are fine, but in pos 2, they sometimes dont work. This is similar
for both left and right. I can get them to work by "joggling" the stalk a little...
I am guessing that this is more of a physical "switch" problem rather than relay etc ? The hazards work fine. Are they easy to take
apart and fix ?
Cheers
MK Indy - 2litre Duratec - Omex 600 - Jenvey throttle bodies - ETB DigiDash2
|
|
|
|
|
MakeEverything
|
| posted on 20/10/09 at 08:58 AM |
|
|
Yep, sounds like the contacts and the switch itself.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
ashg
|
| posted on 20/10/09 at 12:17 PM |
|
|
squirt of wd40 and a bit of a wiggle will sort that out.
Anything With Tits or Wheels Will cost you MONEY!!
Haynes Roadster (Finished)
Exocet (Finished & Sold)
New Project (Started)
|
|
|
matt_gsxr
|
| posted on 20/10/09 at 03:18 PM |
|
|
if you open up the stalk (a couple of clippy bits if I remember correctly) then you can give it a good clean and fill it with vasoline. It improves
the action and may make it last longer.
Don't lose the little springs.
Matt
|
|
|
karlak
|
| posted on 20/10/09 at 06:59 PM |
|
|
Cheers Guys, will give it a go this weekend
MK Indy - 2litre Duratec - Omex 600 - Jenvey throttle bodies - ETB DigiDash2
|
|
|
