dan8400
|
| posted on 26/1/10 at 02:45 PM |
|
|
Telemetrix tacho and megajolt
Can i just connect my smiths telemetrix input wire to the 'tach out' wire on the megajolt?
Don't want to fry the tacho it was expensive lol
Thanks
Dan
|
|
|
|
|
irvined
|
| posted on 26/1/10 at 02:55 PM |
|
|
Yes, that's what I've done. You can also use the tach output signal from the EDIS module if you like too.
http://irvined.blogspot.com
|
|
|
dan8400
|
| posted on 26/1/10 at 03:51 PM |
|
|
Instead of, or as well as. Don't need both do i?
Best to double check
Dan
|
|
|
cd.thomson
|
| posted on 26/1/10 at 04:38 PM |
|
|
no, its either/or
this is my job for this evening too - you've officially overtaken me on your build dan!
just take the tacho out from megajolt to the input on your rev counter. I believe the other method that old rev counters work is by receiving a high
voltage kickback from the coil, so this is the milder of the two methods and even if wrong (its not wrong!) you wont fry it.
[Edited on 26/1/10 by cd.thomson]
Craig
|
|
|
