stuleah
|
| posted on 4/2/10 at 07:29 PM |
|
|
help with wiring tacho on zetec engine
as title says i am trying to wire in a koso digi dash on my zetec engine but i am not sure where the best place to get the rev pick up is, any
suggestions. 
|
|
|
|
|
doddy
|
| posted on 4/2/10 at 07:33 PM |
|
|
what ecu are you using
|
|
|
stuleah
|
| posted on 4/2/10 at 07:36 PM |
|
|
its an owls
|
|
|
big_wasa
|
| posted on 4/2/10 at 07:38 PM |
|
|
you could try the pin I labelled Tacho 
|
|
|
stuleah
|
| posted on 4/2/10 at 07:40 PM |
|
|
didnt see that and just sent you u2u, is that on the ecu or where do i look?
|
|
|
big_wasa
|
| posted on 4/2/10 at 07:42 PM |
|
|
near the immobilizer stsaus led there was a couple of wires with masking tape. One being low oil presure warning light and the other being tacho
|
|
|
stuleah
|
| posted on 4/2/10 at 07:43 PM |
|
|
that rings a bell
|
|
|
