nick205
|
| posted on 6/5/04 at 11:12 PM |
|
|
Pinto temp sender???
Question...
I started with a Pinto that used the ESC2 engine management system and weber 30/34 DFTH carb where the engine coolant temp sender is located in the
inlet manifold.
I have now changed the inlet manifold and carb for a setup from a Capri with a 32/36DGV carb, but the coolant temp sender was fitted in the cylibder
head on that engine.
How can a I get a coolant temp sender fitted???
Cheers
Nick
|
|
|
|
|
macspeedy
|
| posted on 7/5/04 at 08:29 PM |
|
|
on the head i have it just screws into the head beside inlet port on no1 small brass thing have one spare if you want it!
|
|
|
bob
|
| posted on 8/5/04 at 07:12 AM |
|
|
The ford temp sender for pintos will only match/work if you are using the ford dash/pod.
You may need to contact suplier of seperate clocks or dials to match the gauge to the sender.
I had this problem with my racetech temp gauge,rally design or merlin motorsport can supply.
[Edited on 8/5/04 by bob]
|
|
|
