Luego.2.0
|
| posted on 3/11/15 at 04:26 PM |
|
|
Luego zetec electrical gremlin
Hi all
Took the battery off to charge it. Since putting back on I've
Noticed the side and head lights at the front , both brake and side lights on the rear and are not working. Indicators hazards and all other functions
are working ok. I've checked all the viable fuses and swapped relays around, all with no joy?
Anybody got any ideas before I hurt my head banging it on the wall.
Cheers steve
Veinto 2.0 black top.
Jenevy throttle bodies
Omex ecu
|
|
|
|
|
kj
|
| posted on 3/11/15 at 04:35 PM |
|
|
Bad earth all earth leads back on nothing worked loose.
Think about it, think about it again and then do it.
|
|
|
Luego.2.0
|
| posted on 3/11/15 at 06:26 PM |
|
|
They all looked ok I'm going to go back down the the unit
And have another check.
Veinto 2.0 black top.
Jenevy throttle bodies
Omex ecu
|
|
|
rusty nuts
|
| posted on 3/11/15 at 07:57 PM |
|
|
What switch gear do you have? What wiring loom? Did you refit all disconnected cables? Might be worth checking at the switch for a live feed in and
out , same for the brake lights .
|
|
|
Luego.2.0
|
| posted on 4/11/15 at 11:56 AM |
|
|
I think it's a luego made loom. Ford switches on the colour
Had a llom around after wiggling some wire near bottom of the rack the lights came back on.
Only issue now is the brake lights aren't working. Is the a switch for the lights I couldn't see one on the pedal box?
Veinto 2.0 black top.
Jenevy throttle bodies
Omex ecu
|
|
|
rusty nuts
|
| posted on 4/11/15 at 06:33 PM |
|
|
It depends on which type of switch the original builder fitted , no two kit cars are built the same . Chances are there is a pressure switch installed
in the front pipe work , trace the pipes and check for a switch. Hydraulic switches do seem to cause a few problems in kit cars , do a search
it's been covered several times.
|
|
|
Luego.2.0
|
| posted on 4/11/15 at 09:17 PM |
|
|
Thanks mate
Just had a look online to see what I'm looking for. Hopefully easy fix as im at rockingham on Sunday.
Veinto 2.0 black top.
Jenevy throttle bodies
Omex ecu
|
|
|
Luego.2.0
|
| posted on 5/11/15 at 01:12 PM |
|
|
Thanks rusty nuts
Found the sensor just under the nose cone on the pipework
Like you said. Found a replacement in a little motor factors in milton keynes
Thanks again mate
Veinto 2.0 black top.
Jenevy throttle bodies
Omex ecu
|
|
|
.jpg)
