mikeb
|
| posted on 26/5/17 at 03:25 PM |
|
|
Type 9 Reverse Switch Connector
I'm onto almost the last wiring job, the reverse light. I don't have the two pin connector for the type 9 reverse switch. Any one any
ideas where to get one or recommend something that will work?
Thanks
Mike
[Edited on 26/5/17 by mikeb]
|
|
|
|
|
rash12
|
| posted on 26/5/17 at 04:26 PM |
|
|
pricy but there are some on ebay 201928617651
Seller assumes all responsibility for this listing.
[Edited on 26/5/17 by rash12]
|
|
|
rusty nuts
|
| posted on 26/5/17 at 04:38 PM |
|
|
Would a connector from a Focus or Ka fit? Should be easy to find one of those.
|
|
|
stripe
|
| posted on 26/5/17 at 05:01 PM |
|
|
the female bullet crimp connectors just fit over the pins
|
|
|
big-vee-twin
|
| posted on 26/5/17 at 11:03 PM |
|
|
I soldered two wires onto the switch covered each with heat shrink insulation then used crimp bullet connectors
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
mikeb
|
| posted on 27/5/17 at 06:05 AM |
|
|
Great thanks. I tried bullet connector over the terminals but didn't seem very good. Will try soldering
|
|
|
.jpg)
