shed
|
| posted on 26/3/05 at 12:22 AM |
|
|
SPEEDOHEALER
i have just put a speedohealer on my car and was hopeing someone could save me some time...i have a 3.92 diff with 15x60x195 tyres and a R1
engine...does anyone know the code for the speedohealer..
THANKS
|
|
|
|
|
subk2002
|
| posted on 26/3/05 at 09:09 AM |
|
|
I cant remember of hand. But all i done was marked the back wheel were it met the floor. Then rolled the car forward until the make came back round
to met the floor . Then mearure from mark to mark and do some calculations . You can find all the stuff on there web site.
Cheers Drew
|
|
|
shed
|
| posted on 26/3/05 at 10:09 AM |
|
|
i will try that thanks
|
|
|
Hellfire
|
| posted on 26/3/05 at 10:41 AM |
|
|
It was a long shot anyway eh 
|
|
|
subk2002
|
| posted on 26/3/05 at 01:41 PM |
|
|
Here is a link http://www.speedohealer.com
|
|
|
kurt
|
| posted on 27/3/05 at 09:55 AM |
|
|
Speedohealer R1 wiring
I have been in touch with speedohealer via their website and they were very helpful they should be able to tell you what you need to know.
I am also building an MKR1 Indy and need some help with the wiring from the Sierra ignition switch to the R1 loom. I have identified the connectors
on the R1 loom but don't know how to connect these to the Sierra ignition switch. The R1 ignition switch appears to have 3 positions with
paired connections, whereas the Sierra has 2 positions plus the start position. Also do I short out the clutch switch and the side stand switch to
con the diagnostics, and what do I do with the startbutton connector. I would very much like some help with this, explanation or diagram.
Thanks in advance of any help from anybody, anywhere. Post a reply or email kurtnjoolz@tiscali.co.uk
|
|
|
